The Dutch manual can be downloaded from the Roco website. For Linux, the drivers are part of the standard kernel distribution. The ZTC521 (with XBus V3.0 software) has yet to be tested, so the full extent of what is supported is not known at this time. Select «Lenz LIUSB Ethernet» from the top selection box. Viessmann The Viessmann Commander’s Low Speed Bus port supports the XPressNet protocol. We should be able to use this to connect using one of the supported XPressNet computer interfaces, but the limitations of this port have not been determined. Download the new firmware from Hornby connect up the Elite to the PC with a standard USB cable and follow instructions.
Connecting using a Lenz LIUSB and the Lenz LIUSB Server (Windows Only)Note: The first JMRI release supporting the Lenz LIUSB Server connection is 2.7.2 To connect your computer to one of these XPressNet based DCC systems, you can use a Lenz LIUSB interface unit and the Lenz LIUSB Server software. The Lenz LI101F is Lenz’s latest serial port based computer interface. It is significantly different than the LI100 and LI100F in physical appearance, and in the method by which the device is configured. These devices should be configured as LI100F devices with the port speed set to 19,200bps. Please Note: Most of our products are not user serviceable. If a defect or accidental damage occurs, return the unit directly to Digitrax for service. The start up direction has been changed along with the way the segements fill in on the new firmwareSo it’s for beginners?
Shrink may be peeled back to expose pads for adding function wires. Roco Note: Roco calls their XPressNet implementation «RocoNet». The Roco LocoMaus 2 (Roco Part number 10760) has been shown to support operating equipment on a layout (running trains and throwing switches) as well as programming locomotives on the programming track. Max 16 x 16 input modules (256 inputs);- Interface for DR502xEXT modules (bi-directioneel). Track-Output- DCC rail-output.