This quad features GPS positioning, auto return to home, and auto pathfinder (waypoint) functions. Navigate to the cyclop_plus.ino file and open it in the Arduino development environment. Load CYCLOP+ The SH1106 version firmware file is called cyclop_plus_sh1106.hex and can be downloaded via this link: (right-click and download) If you do not install an OLED, you can use either binary.
The settings are saved when the Exit option is selected. Execute a write. If everything is set up correctly the LED on the receiver board next to the ISP pin header will light up for a minute or so. Version History 1.6 Favourite band selection, Improved button timing, menu based interface — WORK IN PROGRESS — NOT YET RELEASED 1.5 Full 48 channel Low Band support added. Introduction and Functions The major function of this project (CYCLOP+) is to add the ability to manually select channels using only the standard channel button on the receiver of the Quanum Cyclops. Words of Warning Use of the FW is on your own risk. Connect the programmer to the ICSP contact on the receiver board.
The default programming tool from the processor manufacturer AVR is called AVRDUDE (seriously). This is command line tool and is horrible to use. Oversized product,we can only ship one per order Wholesale Inquiry Bulk Buy Discounts Order 3 or more and enjoy the savings. The pins should point upwards on the same side as the receiver tin can is installed. Select the type of MCU (Atmega 328p). Select your CYCLOP+ firmware file in the Flash box. Qty (unit) 1 3 10 30 100 Price ฿ Looking for more wholesale prices, Wholesale Inquiry Order this & earn 3 Banggood points Add to Wishlist(1411 Adds).